Page 3
 

SO-CAL Speed Shop Brake Line Kit Installation Instructions - continued


  • STEP 21:
    When you’re ready, you can do the final installation. Remember, all the fittings in this kit, with the exception of the brass fittings on the Wilwood components, are of the inverted-flare style and do NOT need to be sealed. The brass fittings, where they are installed into the Wilwood components, DO need to be sealed with either Permatex sealant or with teflon tape. NOTE: When using teflon tape be sure to start it one thread away from the end of the thread so as not to block the hole and cause a brake problem. Don’t forget, we highly recommend you also use a Panhard bar with a transverse leaf sprung front end.

Click
  • STEP 22:

Click
  • STEP 23:

Click
  • STEP 24:

Click
  • STEP 25:

Click
  • STEP 26:

Click
  • STEP 27:

Click